Ideal-Air Pro Series Dehumidifier | 180 Pints/Day

The Pro Series 180 Pint is rated directly at grow room conditions (86°F, 80% RH), so the 180 pints/day figure already reflects real-world performance in your environment. The dual-rating on smaller Ideal-Air units, such as the Ideal-Air 50 Pint Dehumidifier, exists because those models were re-benchmarked to AHAM standards — the 180 Pint Pro Series capacity is stated at the conditions that matter most to growers.

Yes. Ideal-Air strongly recommends a dedicated electrical circuit and a surge protector for this unit. Drawing 12.31 amps at 1,350 watts, it should not share a circuit with other high-draw equipment. A voltage spike during power restoration after an outage can damage the circuit board, which is not covered under warranty.

The built-in condensate pump actively pushes collected water out of the unit rather than relying on gravity, allowing you to route drainage upward or horizontally to a sink, drain, or reservoir. This eliminates the need for the unit to be positioned directly adjacent to a floor drain.

The Pro Series 180 Pint is designed to operate down to 41°F thanks to its built-in automatic defrost system. This prevents coil icing in cooler environments and allows the unit to maintain consistent moisture removal without manual intervention across a temperature range of 41°F to 95°F. For growers looking to optimize their environment, consult our grow room temperature and humidity chart.

Yes. The auto-restart function resumes operation at the previous settings after power is restored. However, Ideal-Air strongly recommends using a surge protector since voltage spikes during power restoration can damage the circuit board — and that type of damage is not covered under warranty.

Yes. Set the unit upright on its feet for a minimum of 3 hours before powering it on for the first time. This allows the refrigerant and compressor oils to settle properly after shipping, which protects the compressor from damage on first start.

The filter is fully removable and washable — pull it out, rinse under water, allow it to dry completely, and reinsert. Regular cleaning maintains optimal airflow, protects the compressor, and helps sustain peak performance for grow room humidity control over the life of the unit.